Applications > Semiconductor > Wire Bonding
Wire Bonding
Integrated circuits continue to shrink in size, and the associated decrease in size of the wire bond pad on both the die and substrate presents substantial challenges in the manufacturing process.
To ensure high device reliability and minimize manufacturing costs, it is important to optimize the wire bonding process to ensure good bond strengths and yields. Poor bond strengths and low yields are often due to upstream contamination sources or the selection of materials in advanced packaging.
Gas plasma technology can be used to clean pads prior to wire bonding to improve bond strengths and yields.
Typical results of pull strength improvement for a quad flat no-lead (QFN) package with bond pads contaminated with epoxy bleed out is displayed in the figure below. The die was attached with conductive epoxy; oven cured; direct plasma treated; and wire bonded with 25-micron wire. A statistically valid set of samples yielded a mean pull strength of 10.00 grams with a CpK of 2.07 with plasma, compared to a mean pull strength of 3.89 and CpK of 0.03 without plasma. Furthermore, the mean shear strength increased from 25.62 grams without plasma to 28.17 grams with plasma.
Related Technical Papers:
Related Products:
AP-1000 Plasma Treatment System
PLC controller with touch screen interface provides industrial reliability and ease of use. Complete system enclosure minimizes footprint.
FlexTRAK™ Plasma Treatment System
The FlexTRAK system offers high-throughput capability of up to 480 substrates or process carriers per hour. Its small chamber volume and proprietary process control enable unmatched short cycle times, while its unique slim structure minimizes floor space requirements.
FlexTRAK-BH™ Plasma Treatment System
The FlexTRAK-BH system is designed for
high-throughput processing of microelectronic boats, trays, or other
flat device carriers, up to 2 boats per plasma cycle.
FlexTRAK-SH™ Plasma Treatment System
The universal architecture of the FlexTRAK-SH system accommodates a wide range of strip sizes in the same system, yielding unmatched production flexibility.
FlexTRAK-WR™ Plasma Treatment System
The FlexTRAK-WR plasma treatment system is designed for
high-throughput processing of semiconductor wafers up to
300mm
(12 in.).
XTRAK Plasma Treatment System
With process capability of up to 180 substrates or carriers per hour, the system's Smart Tune™ management system provides closed-loop control that reduces tuning to less than one second.
PX-Series Plasma Treatment System
PX-Series systems are equipped with an automatic impedance matching network for ease of operation and consistent results.
Semiconductor Applications Team
Scott Szymanski, Semiconductor Market Manager
Mr. Szymanski works to expand strategic alliances, strengthen partnerships with equipment suppliers, and develop future product offerings tailored to the semiconductor market. With 10+ years of experience at major semiconductor companies, he holds a B.S. degree in Mechanical Engineering from UCLA, and an M.B.A. from the University of Phoenix.
Peter Huang, Semiconductor Applications Engineer
Mr. Huang joined March Plasma Systems in 2006. Prior to his appointment at March he has held a variety of positions in L3 Communications, Raytheon and Texas Instruments. Huang has a BS from Chung Yuan University in Taiwan and a MS from the University of Houston.
Ask the Experts
Semiconductor
The Semiconductor Business Group focuses on plasma processes for advanced semiconductor packaging and assembly (ASPA), wafer level packaging (WLP), microelectromechanical systems (MEMS), data storage devices such as thin film read-write heads (TFH) for hard disk drives, and images sensors. More>>>
Medical Device
The Medical Device Business Group is engaged in providing enhanced product performance, more reliable devices and lower cost processes to companies who manufacture leading edge medical devices including cardiac rhythm management products, catheters, stents, ocular devices, and filter media.
More>>>
Printed Circuit Board
Printed circuit board manufacturers work with our PCB Business Group due to the implementation of new materials technology, and smaller geometries in HDI, flex, and rigid flex applications. More>>>